This is a mcu programmar to control NFR2401

使用单片机C语言编的单片机实验板与上位机的串口通信（可接收上位机命令和根据命令给上位机上传上位机需要的数据）程序，可供单片机开发人员参考。-use C language series micro-controller board and PC serial communications (PC can receive orders and orders under the PC to PC to upload the data needed) process for the development of SCM reference.

用于conextop(串口转以太网)的程序，已经测试通过了，非常好用。并且可同过网络调试助手，查看结果-For conextop (Serial to Ethernet) process has been tested, and very easy to use. And can be the same over the network debugging aids, view the results

共搜集了13个有关51单片机的一些基本程序，代码有汇编写成，内容包括计数器、温度检测等等。-collected a total of 13 of the 51 SCM some of the basic procedures, a compilation of code written, including counter, temperature measurement, and so on.

无线模块MC35的应用开发程序。用于GPRS 方面-module MC35 wireless application development process. Respect for GPRS

TC35GSM模块操作C51子程序，项目用的，少加修改就可以应用于开发和学习！-C51 subprogram module TC35GSM operation, the project used, less can be used without modification on the development and learning!

Atmel算法(pid)-步进电机驱动源码 ,不好用你找我,绝对ok! -Atmel algorithm (pid)- stepper motor driver source code, not with you to find me, is absolutely ok!

ATmega16数码管实验基数显示，数码管选通输出在前避免了字码在前产生的乱码，Proteus图-ATmega16 base of digital tube experiments showed that the digital control of strobe output of the former to avoid the code generated by the previous garbled, Proteus map

C51单片机实现对PC键盘的读取与显示 具体细节请参考源程序 将时钟线接入外部中断 数据线接入普通I/O输入输出口-C51 MCU to read the PC keyboard and display details please refer to the source clock line access external interrupt data lines access I/O input and output mouth

easyarm 1138 用c语言开发的 2401无线 发送程序-easyarm1138 c 2401 send

基于51单片机和ad9850实现的信号发生器程序实现输出1k-1m步进可调-51 Based on the AD9850 single-chip computer and realize the signal generator output procedures realize adjustable stepper 1k-1m