C language source code commonly used algorithm commonly used algorithm C languag...

斜度测试程序 * 程序对应的硬件设置为：利而达MSP430-Test44x实验板，斜度计使用的 * 是ADXL202E，数字y连接TA1/P1.2,数据x连接P1.0/TA0,P4.6对应斜度计电源 * 每个方向的斜度显示时都占用三个字符， * 斜度范围为0~90,高于90的，斜度为(180－斜度）-Gradient procedures for the corresponding test procedures* for the hardware set up: Lee MSP430-Test44x of the board, of the use of gradient is the* ADXL202E, the number of y connecting TA1/P1.2, data x connect P1.0/TA0, P4. gradient of 6 corresponds to the power* of the gradient in each direction are occupied by shows that the three characters,* angle range of 0 ~ 90, more than 90, and slope for the (180- angle)

单片机操作串口，同时通过串行助手进行操作显示验证传输的数据正确与否-Single-chip serial port operations, while aides to operate via the serial transmission of data shows that the right to verify whether or not

介绍了公交车IC卡电路图，汇编原程序-introduced the bus IC card circuit, the compilation of the original procedure

M68HC08 及HCS08系列单片机bootloader引导程序源码、示例-M68HC08 and HCS08 MCU Boot bootloader source, sample

ADC0809数据采集系统 ADC0809数据采集系统-ADC0809

采用反正法扫描方法对4X4矩阵式按键进行扫描，判断是哪个按键按下。-Scanning method used in any case law on the 4X4 keypad matrix scan to determine which keys are pressed.

信利公司提供的TSD4254液晶LCD显示器的驱动芯片ST7549T的初始化程序-Truly TSD4254 provided LCD liquid crystal display driver IC ST7549T initialization procedure

基于飞利浦 lpc2104 arm7 微处理器的部分程序-Microprocessor-based Philips lpc2104 arm7 Part of the procedure

FAT12/FAT16/FAT32/NTFS specification

单片机初学入门程序,不停地循环显示数字0~9。-Beginners Introduction to SCM process, a continuous loop display numbers 0 to 9.