8051f330 6 bit digital tube display

usbcan驱动程序，检测can总线的消息。-usbcan driver can detect the message bus.

用8051单片机控制的8个LED等的跑马功能，具有花样变化，暂停和变速功能-By 8051 the control of eight LED functions such as horse racing, with pattern changes, suspension and transmission functions

用51写的旋转式编码器程序，可以让朋友们了解旋转式编码器的基础编程。-Written by 51 rotary encoder could offer my friends understand the rotary encoder based on programming.

MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to

avr单片机学习的 希望对大家有用 -avr Singlechip everyone would like to learn useful

x5045的相关程序，可以在keil c 上运行-X5045 procedures, you can run keil c

常用数据库包（pcb）组件。。。。。。。。。。。。。。。。。。

用STC单片机开发的简单脉冲发生器,用来测试步进驱动器.-With STC to develop a simple single-chip pulse generator, to test the stepper drive.

MAX485应用很广泛,可应用远程传输,信号衰减少.-MAX485 applications is very wide, and can be applied to long-distance transmission, the signal failure reduced.

DES加密算法的－－51单片机C语言程序-DES encryption algorithm- 51 single-chip C Language Program