ADC0809是广泛使用的模／数转换器，在可不采用外部总线结构的单片机系统中(如 由AT89C51组成的系统)。ASC0809的数据线直接与单片结构的I／0 口相连，并由单片机的I／O 口直接对ADC0809进行控制。-ADC0809 is widely used in analog/digital converters, in not using the external bus architecture in the single-chip microcomputer system (such as the composition of the system by the AT89C51). ASC0809 data lines directly with the monolithic structure of I/0 I connected the MCU I/O port directly to control the ADC0809.

优点：中断中只做很少的事情，通常我是在接收中断中post一个信号量，触发别的任务读数据-Advantages: only a small interruption in the things I usually post in the receiving a signal interruption in the amount of time to trigger other mission data

cpu采用扫描方式进行按键查询，按键扫描程序-cpu manner by scanning button inquiries button scanner

需要加入ZLG7290库。可以在ZLG网站下载！ 在KEIL中调试通过！-the need for Wire. ZLG can download! Tuning in KEIL through!

用中断的方式控制lcd的显示，单片机仍然是h83664十六位单片机。此程序包含单片机的接口的配置以及各种写lcd的子程，使用中断来控制lcd顺序显示A－Z，当然，可以换成其他的显示内容，由于接口程序已经编好，只需要把要显示的内容改一下就可以实现其他内容的显示-With interruption control lcd display, single-chip is still 16 Singlechip h83664. This procedure includes the configuration of single-chip interface and a variety of writing a sub-lcd-way, the use of interrupt to control the order in lcd display A-Z, of course, can be replaced by other display content, as a result of interface procedures have been developed only to To display the contents of change can be achieved about the display of other content

独立模块通过到单片机控制，数码管显示。能显示秒，分，时-Independent modules to single-chip microcomputer control, digital tube display. Can show seconds, minutes, hours

LCD T6963驱动程序 LCD T6963驱动程序-LCD Driver T6963 T6963 LCD Driver T6963 LCD Driver

此程序为调试通过的程序，有键盘输入和LED输出的功能-this procedure through the debugging process, LED keyboard input and output functions

SANYO LC72131D+ LA1823，通用的车载收音头源程序。-SANYO LC72131D+ LA1823, GM car radio the first source.

此程序为单片机开发过程中的串口通信演示程序。用 汇编编写，供参考。-procedure for microcontroller development process of serial communications demonstration program. Using a compilation prepared for reference.