Atmel Uart C51程序（主方式）

51单片机浮点子程序固定源码，包含详细说明。

单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.

16位10进制加法程序，KEIL51编写，适合单片机 -16 10 hex addition procedures, KEIL51 preparation for SCM

51方面的一些代码-51 some of the code

AVR驱动OCM12864LCD 字符是以列扫描的方式建立,字符取反.由字模提取软件zimo2.2提取-AVR-driven OCM12864LCD character is a column scanning approach to building, character negation. Zimo2.2 extracted from the matrix extraction software

红外遥控器的接收程序的另一个版本，其中的显示驱动不同-infrared remote control procedures for the reception of the second version, which shows the different drives

液晶显示模块。在lcd上显示数字的函数。-display of the lcd

自己写的用AVR 单片机产生正弦波.用示波器观察波形很好！-Write your own single-chip generated sine wave with AVR. Oscilloscope to observe waveforms with very good!

c8051f020 的扩展8255驱动数码管显示 同样是keilc啊-C8051F020-driven expansion of 8255 is a digital tube display the same keilc ah

三相异步电动机直接转矩控制仿真程序，经调试通过，与大家共分享-DTC Control