cc1100 rf init how cc1100 initialization register of the sending and acceptance...

精确到秒，上电后开始走表，按键K2选择调整位，闪烁后按键K1加，按键K2第四次回到现实状态-Precise to the second, after power-walk table, adjust-bit key K2 choice, after flashing buttons plus K1, K2 keys back to reality the state of the Fourth

温度控制的程序，自动调节蒸汽开度阀和风机的运行，来达到控制温度的要求-Temperature control program, automatically adjusts the output temperature control

两位数码管动态显示，两个按钮可使数码管数字调大调小-Two digital tube dynamic display, two buttons will enable the digital tube digital transfer major small

、新华龙C8051f340的中文开发资料、-, The new Chinese C8051f340 hualong development information,

基于pic18f2580实现的 定时器0程序 编译器为picc18-Based on pic18f2580 realize timer 0 program compiler for picc18

关于msp430单片机的一些 自己收集的一些有需要的请下载-MSP430 MCU on some of his own collection of some of those in need, please download

单片机电子琴，可以通过单片机按键弹奏乐曲单片机采用89C52.-SCM flower, the MCU can play music keys used 89C52 microcontroller.

单片机控制步进电机加减速C语言源程序，通过不断改变定时器的定时初值来提高频率。-Single-chip stepper motor control acceleration and deceleration C language source program, by changing the timing timer to improve the frequency of the initial value.

L297+L298控制步进电机，用proteus进行仿真-L297+ L298 stepper motor control, using Proteus simulation

点阵数码的驱动 例子显示“欢迎光临” 左右和上下交替显示-Examples of the digital dot-matrix driven displays " Welcome to" turn around and up and down display