SAMSUNG S3C4510B 键盘驱动

linux下的jtag仿真器程序，可使用在arm7（44b0，4510，2410等）和arm9上面，可以烧写flash 39lv160等，再不用两个系统不停重启了。-the JTAG Emulator procedures, the use of the ARM7 (44b0, 4510,2410) and arm9 above, 39lv160 burning flash, no longer have to keep two systems resumed.

使用C51做的电子钟，刚出炉的哟，谢谢大家-C51 make use of the electronic bell, fresh yo, thank you everyone

这是运行在S3C2440+linxu上的SPI控制器驱动程序，里面包含Makefile-This is running on S3C2440+ Linxu the SPI controller driver, which contains Makefile

ARM Cortex-M3 系列处理器 的实验代码，内容很全，涉及片内和外围所有部件编程。（Keil环境） -ARM Cortex-M3 family of processors experimental code, content is very wide, involving all the components and peripherals on-chip programming. (Keil environment)

这是一个原始的DT930的运行程序！直接下载到DT930中就可以使用！-This is a primitive operation procedures DT930! Directly downloaded to the DT930 can be used!

读连接在44b0 PG口PG4 位的ds18b20的64位ROM码。-Reading 44b0 PG connected to the place I PG4 ds18b20 ROM of 64 yards.

资源描述《设计与验证Verilog HDL》_吴继华_光盘资料（参考代码），设计与验证Verilog HDL配套的代码。

sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. SD目录 : SD卡读写模块的全部文件,一般不用修改. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改,而sdconfig.h通常会有改动. -sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. SD directory: SD card reader module all the documents, the general need not be amended. sdconfig.h document recommends not to put in SD directory, because the SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

Setting Up TMS320 DSP Interrupts in C-Setting Up TMS320 DSP Interrupts in C

C8051F 读写24C01 使用SMBus硬件端口-c8051f read and write 24c01 with smbus port.