这是运行在S3C2440+linxu上的SPI控制器驱动程序，里面包含Makefile...

关于ETR100的设计，包括驱动和关键程序，基于成都英创公司的netbox进行开发。-Muti on the design, including the drivers and key procedures, Based on the Chengdu-British Company for the development of the netbox.

基于S3C2440，一个LED灯的驱动程序。-Based on S3C2440, an LED lamp driver.

好的学习资料arm7任何起步学好LIUNX下的AM7-ARM7 any good learning materials LIUNX started to learn under AM7

STM32是以Cortex-M3为核的处理器，该例程介绍STM32下如何对DMA进行操作。在许多情况下需要用到DMA，比如USB的批量传输等。-Cortex-M3 based STM32-core processor for the routine introduction STM32 how to operate on the DMA. In many cases the need to use DMA, such as USB bulk transfer.

arm_jtag debug tool for windows2

基于三星的44b0或2410微处理器的中断控制程序-Based on Samsung

MSP430F149键盘输入程序，利用msp430f149单片机的p1端口输入-MSP430F149 keyboard input program, the use of the port input msp430f149 SCM p1

此为基于ARM的LCD液晶显示器的程序,采用C语言编写,产生正弦曲线-This is based on the ARM-LCD liquid crystal display procedures, the use of C language, resulting in sinusoid

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.