mvdr

说明：  三个ANSYS瞬态分析的命令流：冲击载荷作用悬臂梁的阻尼振动分析；破碎锤的瞬态动力学分析；滑动摩擦接触分析(Three command streams of ANSYS transient analysis: damped vibration analysis of cantilever beam under impact load; transient dynamic analysis of crushing hammer; sliding friction contact analysis)

说明：  龙门吊反演滑膜变结构控制，simlink程序+s函数程序，亲测有效(Sliding membrane control of gantry crane inversion)

说明：  魔术轮胎公式，车辆动力学中常用的关于轮胎的建模(magic tire,used in vehicle model.)

说明：  将一个50Hz的干扰信号加入到白噪声中，然后对合成信号做fft，得到相应的幅频谱图和相位谱图。(A 50 Hz interference signal is added to the white noise, and then the composite signal is FFT to get the corresponding amplitude spectrum and phase spectrum.)

估算锂电池soc的MATLAB simulink模型(MATLAB Simulink model for estimating SOC of lithium battery)

说明：  薄壁圆柱壳轴压屈曲非线性计算，采用模态缺陷作为初始缺陷(In the nonlinear calculation of thin-walled cylindrical shells under axial compression, modal defects are used as initial defects)

说明：  abaqus 帮助文档中的蠕变本构模型，包括时效强化模型和应变强化模型，以及一个模型的inp文件(Creep constitutive model in abaqus help document, including time-based reinforcement model and strain reinforcement model, and inp file of a model)

对等边直角三角形阵和立体三棱锥阵进行仿真建模，并进行了定向定位的误差分析，得到了相应的波形。(The simulation modeling of the equilateral triangle array and the stereoscopic three pyramid array is carried out, and the error analysis of directional positioning is carried out, and the corresponding waveforms are obtained.)

通过频谱来模拟波浪，程序为Jonswap谱的波浪模拟，可随意调整谱参数、时间间隔和模拟的时间长度(The wave is simulated by the spectrum, and the program is a wave simulation of the Jonswap spectrum. The spectral parameters, time interval and length of the simulation can be adjusted at will.)

说明：  电机矢量控制仿真（svpwm方法）实测有效 包括坐标变换(vector control The simulation of motor vector control (SVPWM) includes coordinate transformation)