Reachability

BOOT引导IAP应用演示程序-目标MCU:MEGA8 晶振:外部(EXT) 8MHZ (BOOT boot IAP application demo program- Target MCU: MEGA8 Crystal: External (EXT) 8MHZ)

STC51的串口程序，通过STC51工具连接电脑可以用串口助手模拟(STC51 UART)

Code written in MPLAB for I2C with PIC18f45k80

HCS08的AD例程：本程序是ADC模块的例程，所用资源为单片机内部ADC转换模块， 所接器件为电位器.(HCS08 s AD routine: This is the ADC module of the routine procedure, the use of resources within the ADC conversion for the microcontroller module, the device is connected potentiometer.)

网络控制单片机proteus仿真 利用网络控制单片机的LED、LCD，我只是整理了一下，方便大家学习，版权归原作者，网页也麻烦站长做好了，有一个上位机，点击自动运行一段程序和打开www.mcufz.com/tcp.htm，之后会自动关闭，有的杀毒软件会报是病毒，放心使用。 开始要安装一个WinPcap软件，不安装它不能仿真，然后运行仿真文件，过一会可以看到LCD显示出了IP地址50。1。1。1 (Proteus simulation network control the use of single-chip microcontroller network control LED, LCD, I am just finishing a bit, to facilitate learning, belongs to original author, the website also do a good job of head trouble, there is a host computer, click Automatic operation for some procedures and open www.mcufz.com/tcp.htm, will automatically shut down after some anti-virus software will be reported to viruses, ease of use. WinPcap started to install a software, do not install it can not simulation, and then run the simulation documents LCD moment we can see the IP addresses shows that 50. 1. 1.1)

基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)

125k t5557卡 读写(keil C51 T5557 READER)

一个能读取DHT11湿度传感器的程序，使用STM8S003K3P6(A program to read DHT11 humidity sensor)

PIC Microcontroller project Door lock with PIC16f84a

NTC测温程序的查表方法--经典的二分法。(NTC thermistor temperature measurement program)