Standard-CPP

stm32f103zet6读写EEPRAM的例子，固件库是V3.5版本的(stm32f103zet6 read EEPRAM example, firmware version V3.5 library is)

自动交通控制系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁示线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）(Automatic traffic control system using red, green, yellow light-emitting diodes, said a total of three traffic lights, the use of single-chip analog time display on a regular traffic signal control and management. Changes of lights to be as follows: 1) Release Line: green clearance 25 seconds, the yellow light warning for 5 seconds, then the red light is prohibited. 2) ban shows lines: the red light is prohibited for 30 seconds, then the green light to release. 3) When the red light in one direction, if the direction of the car through, the alarm speaker sound. (Hit the red signal available 3-5V analog representation))

温湿度检测 AM32101温湿度传感器 可以检测(Temperature and humidity sensor temperature and humidity testing AM32101)

jm20316移动硬盘盒---原理图，PCB板图。非常好用的资料(jm20316 HDD Enclosure--- schematics, PCB board map. Very useful information)

For this project you need a 3.7v power supply that prepared by LM317 regulator. So you need MAX232 for connect uart to pc .my AVR chip project is Mega8 that you can program on any Avr chip have 2kbyte rom. In bascom spi hardware don’t work correct, so I have to software spi ,but the software spi configure have low speed into hardware spi.

串口下发至数码管显示，本程序已通过编译，可直接使用(Serial issued to the digital display, the program has been compiled, can be used directly)

说明：  一个基于kinect的鼠标小程序~~~用vs2008环境(A small program based on kinect mouse ~ ~ ~ with the vs2008 environment)

HM20通用型压力变送器 资料很全 值得下载 (HM20 Universal Pressure Transmitter)

矩阵按键测试程序, 输出结果用串口传输到上位机显示(Matrix key test program, the output with serial transmission to the PC)

430 单片机的i2c程序，430有i2c集成(this is an I2C program of 430)