clark_park

在 8X8 点阵式 LED 显示“★”、“●”和心形图，通过按键来选择要显示的 图形。(Style LED display ★ , ● and heart-shaped figure in 8X8 lattice to the graphics to be displayed by the button.)

利用红外遥控器来遥控LED灯的亮灭，8个按键可以控制8个LED灯，实现智能遥控灯(The use of infrared remote control to remote control the LED lights on or off, 8 buttons can control 8 LED lights, to achieve intelligent remote control lights)

键盘控制lcd1602的显示，一个按键实现位置选择，其余两个按键实现数字的加减(The keyboard control lcd1602 the show, a key position select the remaining two buttons digit addition and subtraction)

本文从硬件出发，系统地讲解了文件系统实现的原理，内容详细全面而有条理(Starting from the hardware, this paper systematically explains the principle of file system implementation. The content is detailed, comprehensive and orderly.)

oled的显示驱动程序，都是自己写的，可以移植到51，avr stm8都可以使用，(oled display drivers are written in their own, can be ported to 51, avr stm8 can be used,)

单片机的protues仿真实验，包括单片机最小系统，AD1208，DA1674,AT24C02的仿真(SCM protues simulation experiments, including the smallest single-chip system, AD1208, DA1674, AT24C02 simulation)

以单片机为主控制器，开发一个液位监控系统，可测量并显示液位高度。设定最高液位和最低液位，当液位高于最高液位或低于最低液位时发出报警信号。(Microcontroller-based controller, the development of a level monitoring system to measure and display the liquid level. Set a maximum level and minimum level, an alarm signal when the level is above the maximum level or below the minimum level.)

了解 CAN 总线通信原理，实现利用 CAN 总线完成通信 在进行实验的时候，需要将两块开发板连接 USB 线进行充电，因为利用 CAN 总线进 行通信需要有较高的驱动能力。(Learn CAN bus communication theory, to achieve complete CAN bus communication when carrying out the experiment, you will need two development boards connect the USB cable for charging, because the use of CAN bus communication requires a higher drive capability.)

基于PSCAD软件环境，实现永磁同步风力发电机的软件仿真，能够模拟各种情景下的风力发电机输出与风力关系的仿真。(PSCAD-based software environment, to achieve permanent magnet synchronous wind turbine simulation，it can simulate various scenarios of wind turbine simulation of the relationship between output and wind.)

RFID RC522 sample code.