k_eps

It can be used to simulate body force in Discrete Particle Model (DPM) in ANSYS FLUENT v14.5

跑马灯设计，主要是利用51单片机完成跑马灯的设计(Marquee design)

电协开发板 C51单片机程序，用于实现单片机的流水灯输出(Electric Association C51 microcontroller development board procedures for the realization of single-chip light water output)

这是Small RTOS 51 在DP－51下载仿真实验仪上使用CAT24WC02驱动程序的例子。本例程序按照相应的的通讯协议接收一个数据，并将接收到的数据显示到LED数码显示器上。然后将接收到的数据写入Cat24Wc02中，再在同一位置将数据读出，并将读出的数据通过串口发送回来。通讯协议参考rtos随想曲和test.ini。 (This is the Small RTOS 51 DP-51 download simulation NG use CAT24WC 02 Driver for example. The cases in accordance with the relevant procedures of receiving a communication protocol data and receiving the data shows that the LED digital display. Then sending the data into Cat24Wc02, again in the same position will be read out data, will be read out through the serial data sent back. Communication protocol reference rtos test.ini and Capriccio.)

uCOS+uCGUI例程，主控芯片为STM32，LCD采用FSMC接口连接，实现图形界面的操作(uCOS+uCGUI routines, the main chip for the STM32, the LCD FSMC interface connector, the operation of the graphical interface)

双馈风电机组的PSCAD模型，是通用模型，有助于帮助解决双馈风电机组建模问题(PSCAD doubly-fed motor model)

智能车开发串口接收数据上位机软件.源代码.如果自己加上数据分析功能,就非常有用.(Development of intelligent vehicle PC software serial receive data. The source code. If they combined data analysis, it is very useful.)

华中科大第八届的程序 拿了赛区的二等奖 关于飞思卡尔智能车电磁组(sensor group)

说明：  一个很通用的按键扫描程序，可用于单片机控制中(A very common key scanner can be used in the SCM)

C++ SDK绘图。涉及函数：WinProc Draw(C++ SDK graphics. Related to function: WinProc Draw)