fault-analysis

fuzzy model single input single output

AVO PP摸模拟及分类程序，其中包括了模拟计算程序，分类数据等(AVO PP touch simulation and classification procedures, including the simulation calculation program, data classification etc.)

高斯混合模型关于高斯混合模型（GMM）的matlab源代码(on Gaussian mixture model (GMM) Matlab source code)

X射线检测中黑度与透照参数分布曲线的最小二乘拟合(X-ray inspection of the least-squares fit blackness and Radiographic parameters distribution curve)

说明：  信号的叠加、信号叠加后不超标时间的计算、fourier级数拟合(Superimposed on the signal, not excessive computing time after the signal is superimposed, fourier series fit)

用于提取LPC参数的MATLAB程序，并通过MATLAB展示出参数图形。(MATLAB program used to extract the LPC parameters, and by the graphics of MATLAB demonstrated parameters.)

关于直流电机的空载特性的matlab仿真，采用的是样条插值算法对曲线进行拟合，初学者可以改为其他拟合方式看结果如何(With regard to the no-load characteristics of DC motor matlab simulation, using the spline interpolation algorithm, beginners can be fitted into other ways to see the results)

利用蒙特卡罗法计算积分，感觉很有用，大家试试！(Using Monte Carlo method to calculate points, feel useful, we try!)

simlink的开发和框图还有s文件通过它可跟好的了解simlink的使用(Block Diagram of the development and simlink)

采用有限单元法计算平面刚架自振频率，可生成单刚、单元质量阵并组成总刚、总质量矩阵，并绘图显示。(Plane frame using the finite element method to calculate the natural frequency can be generated just a single unit consisting of the total mass matrix and just total mass matrix, and graphics.)