LCD

STM32 SPI口的应用例程，可是设置成主模式或者从模式。(STM32 SPI routine application of the mouth, but set to master mode or slave mode.)

LCD液晶显示程序，在AT89S52上运行成功，其也可以用于其 他的处理器(LCD liquid crystal display program, run on AT89S52 is successful, it can also be used for the processor)

MSP430F147 FLASH功能例程

一个能读取DHT11湿度传感器的程序，使用STM8S003K3P6(A program to read DHT11 humidity sensor)

用138,595控制的点阵，附带两个不同控制方式的源程序以及电路连接图，(With 138,595 dot control, with two different control modes of the source and a circuit connection diagram,)

基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)

单片机初学者资料 51单片机C语言编程入门(详讲版)(Singlechip beginners )

nRF905接收程序,可与k60连接进行无线通信(RF905 receiving program can communicate wirelessly connect with k60)

说明：  基于51单片机红外遥控智能小车（原理图、PCB、遥控器控制程序、实物图）(ntelligent car based on 51 microcontroller infrared remote control (schematic diagram, PCB, remote control program, physical map).)

BOOT引导IAP应用演示程序-目标MCU:MEGA8 晶振:外部(EXT) 8MHZ (BOOT boot IAP application demo program- Target MCU: MEGA8 Crystal: External (EXT) 8MHZ)