KVTR100_EN_M_B11

由两个火焰传感器和一个360舵机一个180度舵机组成的红外定位灭火系统，可以定位火源方向，将火焰灭掉。(Two flame sensor and a 360-degree steering gear steering gear consisting of a 180-IR positioning fire-fighting system that can locate the direction of fire, extinguish the flame.)

pwm方波控制仿真 通过仿真输出方波pwm 并输出正弦波 谢谢(PWM square wave control simulation by simulation output square wave and sine wave output for PWM)

说明：  STM32F407示波器的设计，程序仅供参考(STM32F407 oscilloscope)

本程序是使用STM32开发蓝宇第四代线性CCD的例程，附有CCD与STM32的接线说明。程序是基于STM32F103ZE单片机的，可移植。(This procedure is the use of STM32 development Lan Yu fourth generation linear CCD routines, with CCD and STM32 wiring instructions. The program is based on the STM32F103ZE microcontroller, which is portable. )

19264驱动显示数字，ASCII，汉字，代码简洁，注释清晰。STC12C5A60S2芯片(19264 drivers display Numbers, ASCII, Chinese characters, the code is concise, clear comments. STC12C5A60S2 chip )

串口调试助手，可显示波形，图像GPS定位，智能车助手(Serial debugging assistant, waveform display, image GPS positioning, intelligent car assistant)

寄存器创建简介 方便新手快速入门学习 简单模块创建(Register Template Establishment)

基于cortex M3的IIc24C02读写数据，在群星系列单片机上验证通过！(Cortex M3 based on the IIc24C02 read and write data to validate the Stars Series MCU through!)

NUC100最小系统！此包含48PIN和100PIN！(Support 8G SD card, personally TESTED!)

使用MDK5编写的程序，利用STM32F103驱动CH395模块利用网口和电脑之间通信，还包含了相关的资料(Using the program written in MDK5, using the STM32F103 to drive the CH395 module to communicate between the network and the computer, the related information is also included.)