HZ

使用MSP430操作12864显示屏，共显示四行。可显示中文汉字(Use MSP430 operation 12864 display four lines total. Can display Chinese characters)

单片机串口发送程序，试一次课设做的，非常非常好用(Chip serial transmission program, try again Lesson set, very, very easy to use)

自动交通控制系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁示线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）(Automatic traffic control system using red, green, yellow light-emitting diodes, said a total of three traffic lights, the use of single-chip analog time display on a regular traffic signal control and management. Changes of lights to be as follows: 1) Release Line: green clearance 25 seconds, the yellow light warning for 5 seconds, then the red light is prohibited. 2) ban shows lines: the red light is prohibited for 30 seconds, then the green light to release. 3) When the red light in one direction, if the direction of the car through, the alarm speaker sound. (Hit the red signal available 3-5V analog representation))

通过RS485端口不停地发送数据0xaa用示波器观察RS485端口A、B信号线上的波形或者用RS485接收器接收发送的字符。(Through the RS485 port to send data continuously 0xaa observed with an oscilloscope RS485 ports A, B signal waveforms or use the RS485 line receiver sends characters.)

doccument for engineer of electronics

99秒马表，在Proteus设计两个数码管动态显示及一个键盘SP。在ucos下结合keil完成开始时，显示“00”，第1次按下SP后就开始计时。 第2次按SP后，计时停止。第3次按SP后，计时归零。 (99 seconds stopwatch, two in the Proteus design dynamic digital tube display and a keyboard SP. Keil in combination ucos completed under the beginning of the show " 00" , 1st timer after pressing the SP. 2nd by SP, the time to stop. The 3rd by the SP, the time zero.)

本系统是基于mega16的EEPROM的读写，程序可靠！(The system is based on the mega16 the EEPROM read and write, program and reliable!)

This is a generic FIFO buffer that can be used to store any kind of items. It is written in C language and can be compiled and used on almost any architecture. It was designed to be used on memory limited architectures such as microcontrollers. Examples of the applications that can be built with this library include:

双馈风电机组的PSCAD模型，是通用模型，有助于帮助解决双馈风电机组建模问题(PSCAD doubly-fed motor model)

Other Skin for yous App... simple, you can made more skins for it. Come whit some skins