Untitled2

用來計算帶通濾波器相關參數，可以看出響應圖(Band-pass filter is used to calculate the relevant parameters can be seen in Fig response)

ascii char conversion

该程序利用赫兹理论，计算齿轮的接触应力，适用于直齿和斜齿轮的接触应力计算！(calculating contact stress )

针对多径效应的影响，提出了一种基于矩阵束的MIMO 雷达低仰角快速估计方法。该方法同时考虑了发射多径信号和接收多径信号，采用单样本数信号矢量构造了一个前后向矩阵束，并利用两个酉矩阵对该矩阵束进行降维处理，最后采用广义特征值分解的总体最小二乘法来估计目标角度。算法不需要估计数据协方差矩阵，可在低 信噪比和单样本数情况下，有效地克服多径效应，实现同时多目标低仰角估计，相比最大似然算法，避免了谱峰搜索，计算量小。仿真结果验证了该算法的有效性。(To overcome the multipath effect, a fast algorithm for low elevation estimation for MIMO radar via matrix pencil is proposed. The signals both in transmit multipath and receive multipath are considered. Firstly, a forward-backward matrix pencil is formed based on the single-sampled vector. Secondly, the reduced-dimensional processing is applied to the matrix pencil via two unitary matrices. Finally, the generalized eigen-decomposition is employed to estimate the low elevation in multipath environments directly. Without the covariance matrix estimation, the proposed method can overcome multipath effect effectively in case of low SNR and estimate multi-target simultaneously. Compared with Maximum Likelihood (ML) method, it avoids spectrum peak searching and reduces the computational burden. Numerical results verify the effectiveness of this method)

使用Matlab软件计算Normal Copula,Student t Copula,Clayton Copula,Gumbel Copula的程序(Calculated Normal Copula, Student t Copula, Clayton Copula, Gumbel Copula using Matlab software )

频率响应函数计算程序,通过输入结构的响应数据，识别结构的模态参数，matlab(frequency response function，)

说明：  用卡尔曼滤波方法对圆周运动进行预测的算法实现(Kalman filtering method using circular motion algorithm to predict)

根据物理学的毕奥-萨法尔定理，计算环形线圈周围电磁场的强度。。(According to physics, Biot- Safar theorem, calculate the intensity of electromagnetic field around the circular coil. .)

gmres 方法。视图求解线性方程组A*x=b的解x。nXn的稀疏矩阵A必须是方程且应是大型稀疏矩阵。列向量b的长度必须为n。(gmres method. View solving linear equations A* x = b the solution x. nXn sparse matrix A must be equation and should be large sparse matrix. The length of the column vector b must be to n.)

管中的纵波频散曲线 直接修改其中的矩阵就可以画出频散曲线 (dispersion curvers in pipe)