MFiles

Employing Maximum Mutual Information for Bayesian Classification (Decision Theory)

mfcc with matlab programming

去斜率（strech）参考信号与回波信号混频后得到中频输出信号S(t)=Aexp(j*2*pi*f0*t+phase) 其中f0与回波延时的关系为： f0=k*delay_t K为线性调频斜率，delay_t为回波延时 将s(t)采样，FFT变换即可得到目标距离与频谱的关系。 Strech 信号测距 输入混频后的中频信号（图一），经采样及FFT变换得到频谱（图二） 再根据频谱与距离的关系式R=Tcf/2B显示出距离(图三) (Go slope (strech) obtained after the reference signal and the echo signal mixer IF output signal S (t) = Aexp (j* 2* pi* f0* t+phase) f0 and echo delay relationship: f0 = k* delay_t K chirp slope, delay_t the echo delay sampling s (t), the FFT transform to the target distance spectrum of relations. Strech signal ranging input mixer IF signal (Figure 1), sampling and FFT transform spectrum (Figure 2) according the the spectrum distance relationship R = Tcf/2B shows the distance (Figure 3))

matlab of analysis pictures(analysizing pictures )

说明：  我整理的基于卡曼滤波的盲多用户检测程序，仿真结果是对应不同信噪比时的误码率(I am finishing kaman filtering based on blind multi-user detection procedures, simulation results are corresponding to different signal to noise ratio when the bit error rate)

描述黑体辐射规律，绘制普朗克函数曲线和韦恩定律(Description blackbody radiation law, drawing Planck function curve and Wayne law)

任意直导线周围的磁场分布，使用matlab编制(Arbitrary distribution of magnetic field around the wire straight)

MPC5606的 DMA开发 负责吧数据从变量搬运出去(development DMA )

matlab. ieee 9 bus test system, simulink file

说明：  用于多目标算法的测试，特别是高位多目标的效果比较好，大家可以试试。(Test for multi-objective algorithm)