ACISbook

Termometr read pc com post atmega8 usart

基于keil软件的51单片机程序，18B20测温及12864液晶显示的文件。晶振为12M(Based on the the keil software 51 microcontroller procedure 18B20 temperature measurement and 12864 LCD file. Crystal-12M)

基于蓝牙协议栈BLE4.0的模块CC2541的ADC采集实验(Stack BLE4.0 module CC2541-based Bluetooth protocol ADC acquisition experiment)

在淘宝上购买的毕业论文，价值400的源程序，包含全部文件。一款基于单片机的灭火机器人模型的设计。系统以STC89C52RC单片机为控制核心，创新自制了火焰传感器用来测量火源，使用TCRT5000型光电对管检测循迹黑线，L298驱动电机前后转动，LCD1602液晶显示灭火的次数，通过控制继电器开关风扇灭火。(On Taobao buy thesis, the value of the 400 source code, including all documents. Fire fighting robot model based on a single-chip design. System microcontroller STC89C52RC to control core, innovation homemade flame sensor is used to measure the fire source, tracking black line on the tube use TCRT5000 photoelectric detection, L298 drive motor rotating back and forth, the LCD1602 LCD number of fire-fighting, fire control relay switch fan .)

Full document very cool snd nice

32位单精度浮点数的乘加运算的C编程，感兴趣的可以看一下(Single-precision floating-point multiply-add operation of the C programming, interested can look at)

说明：  利用定时/计数器T0从P1.0输出周期为1s的方波，让发光二极管以1HZ闪烁，设晶振频率为12MHz(The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz)

基于stm32f407的手写识别程序，亲测可用(Handwriting recognition program based on stm32f407)

stm32F410X PCA例程，Stm32F410x很好的学习资料(Stm32F410X PCA routines, stm32F410X very good learning material )

通过51单片机串行转并行，扩展IO口，实现四个步进电动机的控制。(By 51 microcontroller serial to parallel IO expansion port, to achieve four stepper motor control.)