exa080902_dct2

这是调速器模块，参数已经调好，可直接用于柴油机模型(this is very good thank you very much)

与先前上传的文件一样，为通信系统中am调制与解调的matlab程序实现，并仿真实现，程序各行均有完整的说明，简明易懂！(Previously uploaded files, as communication systems for am modulation and demodulation matlab program, and Simulation, procedures, both the description of a complete, concise and understandable!)

Manual Reset Chip KIT (Using the Chip Samsung, Xerox)

Here is a matlab code for describing the effect of shadowing in the wireless channel

机器人定位与kalman滤波的学位论文与源程序(Robot localization and kalman filtering and source of dissertation)

LMS+and+VSS_LMS算法，可在MATLAB7.0 以上的版本应用。(LMS and VSS_LMS CODE with MATLAB. The file include five sub_files.)

自回归滑动平均模型的matlab仿真实验程序(ARMA mode simulation experiment based on matlab)

说明：  载波侦听多路访问。采用分布式控制方法，附接总线的各个结点通过竞争的方式，获得总线的使用权。只有获得使用权的结点才可以向总线发送信息帧，该信息帧将被附接总线的所有结点感知(Carrier Sense Multiple Access. A distributed control method, each attached to the bus node on a competitive basis, to obtain the right to use the bus. Only with the right to use the node can send messages to the bus frame, the message frame will be attached to all nodes sense the bus)

以前使用matlab和vc混合编程都使用的是先将m程序用mcc转化成dll，再在vc中调用 的方法。这种方法对比较复杂的m文件很方便，但是对一些小的程序，如曲线可视化、计算矩阵特征值等，对这些只需要一两行代码的小程序，再使用dll就得不偿失了。经过试验后，发现可以直接在C++程序中调用matlab c/c++ math & graphic library的函数。(before using Matlab and vc mixed programming using the first procedure used mcc m into dl l, then vc call method. This method of complex documents m very easy, but for some minor procedures, such as curve visualization, matrix eigenvalue calculation, and so on, these are just two lines need a small procedure code, reuse dll on the loss outweighs the gain. After testing, can be found directly in the C Programming Calling Matlab c/c math)

风力发电最大功率点跟踪，采用爬山法，matlAB自带永磁同步电机，buck电路降压(Wind power maximum power point tracking, using climbing method, matlAB own permanent magnet synchronous motor, buck buck circuit)