-
Verilog16
16位加法器,需要的拿去,经仿真试验成功的(16-bit adder is needed instead, after a successful simulation test)
- 2007-11-06 00:04:04下载
- 积分:1
-
Rotorsystemcriticalspeedbeforethethird-ordermethod
汽轮机转子系统前三阶临界转速的传递矩阵法(Turbine rotor system critical speed before the third-order transfer matrix method)
- 2009-05-02 16:14:26下载
- 积分:1
-
signal-modulation-and-demodulation
这是关于信号的调制与解调,是通信原理核心部分,也是通信中很常见的(This is about the signal modulation and demodulation, is the core part of communication theory, communication is very common
)
- 2011-07-15 13:42:52下载
- 积分:1
-
ga123245
这是一个有关于遗传算法用于参数优化源码的例子(It is a genetic algorithm is used to optimize the parameters of the source code examples)
- 2007-05-22 00:19:26下载
- 积分:1
-
MATLAB
单自由度系统对初始条件和简谐激励相应
由单自由度的运动方程和初始条件得到二阶非齐次常微分方程,它的解有对应的齐次方程的通解和非齐次方程的特接构成。(Single degree of freedom system to initial conditions and the corresponding harmonic excitation
Special general solution of the equations of motion and initial conditions by a single degree of freedom to get the second order non-homogeneous ordinary differential equations, its solution has a corresponding homogeneous equation and non-homogeneous equation then constituted.)
- 2014-09-19 10:50:48下载
- 积分:1
-
HFT-Code
MATLAB中实现HFT算法,得到显著图(HFT algorithm implemented in MATLAB, has been significantly Figure)
- 2020-10-11 17:47:32下载
- 积分:1
-
work
matlab飞机轨迹自动生成程序,网友可根据自己需求 更改轨迹(trajectory of aircraft programe)
- 2021-04-08 10:39:00下载
- 积分:1
-
PCA
对大量数据进行pca分析,得到表达信息的重要成分,压缩数据(PCA)
- 2010-06-01 18:21:23下载
- 积分:1
-
ujjujujgsd
【matlab编程代做】8QAM通过AWGNchannel后的误码率([Matlab] 8QAM by doing some programming error rate after AWGNchannel)
- 2021-04-08 20:59:00下载
- 积分:1
-
matlab-camera-calibration
基于matlab 的相机标定的几篇论文,标定是机器视觉测量的基础内容。(Camera calibration based on matlab a few paper, calibration is the basis of machine vision measurement.)
- 2015-03-06 17:07:17下载
- 积分:1