cdma

实现MATLAB下的音频AGC,关键是要有高效的算法。效果不错。(MATLAB realize the audio AGC, the key is to have efficient algorithms. Good results.)

linedatas of IEEE standard systems for Optimal power flow

powersystem fault analysis of power_svc_pss

对于无源定位系统，采用扩展卡尔曼滤波的方法对定位精度进行了分析。(For the passive positioning system, using the extended Calman filter method for positioning precision was analyzed.)

说明：  灰色预测法预测电力负荷程序，GM(1,1)(Grey forecasting power load forecasting method procedures, GM (1,1))

Implementing Watermarking using discrete 2-D wavelet transform.

Video Processing. Extract movie frame

试设计一个切比雪夫I型高通数字滤波器，采样率为8000Hz,fp=1000Hz,fs=700Hz,Rp=3dB,Rs=20dB。(Try to design a type I Chebyshev high-pass digital filter sampling rate of 8000Hz, fp = 1000Hz, fs = 700Hz, Rp = 3dB, Rs = 20dB.)

本例程模拟的是额定电压为10kV的单相输电系统. 其主要参数如下：线路首端电压的仿真模块VS电压为14.847kV；电压源等效内阻Rs_eq为 ；相位：0；频率：50Hz；输电线路用 型等效线路替代，线路长度 ；用户端为恒定负荷1000kvar(The main parameters of this paper are as follows: The VS voltage is 14.847kV the equivalent internal resistance Rs_eq of the voltage source is Phase: 0 Frequency: 50Hz Transmission Line-type equivalent line replacement, line length client-side constant load 1000kvar)

说明：  单相桥式整流电路闭环相控调压，simulink中搭建单相桥式整流电路，利用PI控制方式，实现输出电压的相控(The single-phase bridge rectifier circuit is closed-loop phase controlled voltage regulation, the single-phase bridge rectifier circuit is built in Simulink, and the PI control mode is used to realize the phase control of output voltage)