observationLikelihood

MATLAB从入门到精通MATLAB从入门到精通MATLAB从入门到精通MATLAB从入门到精通(MATLAB from entry to entry to the master from the master MATLAB MATLAB MATLAB from entry to the master from entry to the master)

主要是对lorenz系统进行仿真，包括时间序列分析，lyapunov指数的分析等等(Is the lorenz system simulation, including time series analysis, analysis of lyapunov index)

This file has the code for GMM classification technique

matlab 可视化 微分方程 线性方程 元胞自动机 晶体生长 金融(linear equations matlab visualization of cellular automata crystal growth differential financial)

说明：  该程序代码是用于构造非平稳的信号的代码，其统计特性是随时间而变的。(This program code is used to construct non-stationary signals)

我写的用于绘制绘制矩阵图形的小程序，要求matlab版本在6.0以上。(I write for rendering graphics rendering matrix of small procedures, requirements in Matlab version 6.0 and above.)

等腰三角波发生器，在simulink 中有的是锯齿波和三角波的现成模块，可是等腰三角波的就没有了，现提供给大家。(isosceles triangular wave generator, which in some Simulink ramp and triangular wave off-the-shelf modules, But isosceles triangle wave, there is no, it is available to everyone.)

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)

超宽带OFDM通信系统仿真；保护间隔；循环前缀；QPSK 调制(Ultra wideband OFDM communication system simulation protection interval cyclic prefix QPSK modulation )

加性高斯噪声信道下BPSK信道估计，matlab程序，做得还比较好！希望能帮助你们！(AWGN channel under BPSK channel estimation, matlab procedure done better! To help you!)