BPSK

Op Amp details & application

rake reciver simulation in matlab

face protecte program

对确定的一个负反馈系统，进行稳定性判断、最小相位系统判断；求取零点、极点、放大系数；绘制阶跃响应图。(To determine a negative feedback system, judge, judge the stability of minimum phase system calculating the zeros, poles, amplifying coefficient drawing step response diagram.)

This disk contains numerical methods software coded in MATLAB. The algorithms are described in the text NUMERICAL METHODS for Mathematics, Science, and Engineering.FORTRAN

二阶系统一次性完成的最小二乘法辨识程序，便于理解最小二乘辨识的原理(Completed a one-time second-order system least squares identification procedure, easy to understand the principle of least squares identification)

基于C++，实现信号处理中的时延褶积程序(Based on C++ implementation delay signal deconvolution procedure)

my package is all about image processing of counting eggs using bwareaopen to remove noise and filtering of the image, also include how many eggs are there.

说明：  参考维基百科（https://en.wikipedia.org/wiki/Variance-based_sensitivity_analysis）的取样过程以及对应的Estimators。理论性的东西就不进行复述了，这里主要阐述用MATLAB（R2018b）对某个特定函数进行Solo indices敏感性分析的过程。大致可分为四个过程：采样，构建函数，函数输出（将样本带入函数得到输出值），计算Sobol指数（估算一阶影响指数和全局影响指数）(Sobol global sensitivity analysis)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):