本程序是无刷电机控制程序，在

SD2403A时钟芯片在STC单片机下的源程序 此芯片价格便宜，性能稳定！-SD2403A clock chip in the source code under the STC in this single-chip chip prices, performance and stability!

利用8051单片机驱动H6152射频读写模块，实现对非接触式射频卡的读写操作。-8051 drivers to use radio frequency reader module H6152, to realize non-contact RF card read and write operations.

本软件为7279显示控制器软件，用KEIL 7。0编写。-software for the 7279 display controller software, used KEIL 7. 0 prepared.

单片机源程序三位依次显示动态扫描的例子，可以通用-SCM source 3 shows were dynamic scanning example, generic

汇编程序的一些非常实用的初始化程序-Compilation of some very practical procedure initialization procedure

keilC51编写的，配合单片机AT89C51的液晶模块PG12864的驱动显示程序！-keilC51 prepared with AT89C51 single-chip LCD driver module PG12864 display program!

51单片机串口数据包收发程序，能一次收发多个字节，可跟据需要自行修改字节长度，并且具有接收超时判断功能。-51 Single-chip serial data packets to send and receive procedures, can send and receive more than one byte can be modified according to the needs of self-byte length, and have to receive overtime to determine function.

实现交流220V市电的定时开关，可编程修改各参数，特殊情况下可强行开关。主要用于控制自助打印机系统。-AC 220V City realize the timer switch, programmable modify the parameters, special circumstances may be forced switch. Mainly used to control the printer self-help system.

C8051f340的I2C程序，开发环境Silicon IDE-C8051f340 the I2C procedures, Silicon IDE development environment

多任务操作系统ucOSII移植到Keil上的源码-Multi-tasking operating system ucOSII transplanted to the source Keil