《51系列单片机高级实例开发指南》一书的can总线的PC端的源代码...

带T6963C控制器的LCD的驱动程序和简单的显示测试程序-T6963 controller with the LCD driver, and the simple test procedure shows

单片机开发的显示电路设计，里面附有C的源代码-The development of the display of single-chip circuit design, which with C source code

必用的C程序,单片机实现滤波器的方法-Procedures must be used in C, single-chip filter methods realize

我自己写的一个tcp/ip的代码，很短，用的是vc来做模拟调试的，具体的运行是要在mcs51单片机上的，只有一个端口。具体请大家看程序吧！-I wrote it myself a tcp/ip code, in a very short, it was vc do simulation testing, the specific operation is to mcs51 MCU, only one port. Please refer to specific procedures!

AT89C2051驱动步进电机的电路和源码(用keilC51)-AT89C2051 stepper motor drive circuits and source code (using keilC51)

ccx的verilog代码,opensparc 的源代码-verilog of ccx

STC89C58RD +宏芯（driver）驱动TOPPTFT_LCD-STC89C58RD+ Macro-core (driver) driver TOPPTFT_LCD

用于步进电机的驱动.可以通过输出信号来控制步进电机的转速和角度控制.-For stepper motor driver. Can output signals to control the stepper motor speed and angle control.

这个范例说明如何使用8051 的Port 1连接到四颗七段显示器，PORT 0的低4位分别控制这四颗共阳七段显示器，让四颗共阳七段显示器使用扫描的方式轮流-This example shows how to use the 8051 Port 1 connected to four seven-segment display, PORT 0, low 4, respectively to control the total of four seven-segment display yang, so that a total of four seven-segment display yang way of using the scan rotation

悠景2.23oled演示代码，可以在DEMO板显示-Univision 2.23oled demo code, you can board at the DEMO show