我是用89S52做的模拟路灯控制系统。这个作品我在09年的全国大学生电子设计竞赛中获全国一等奖。...

TI TMPS430单片机使用例子，希望对象我一样的初学者有帮助-a sample of using the TMPS430,i hope it will help the new learner as me

ucgui V3.98 是目前网络上相对较新的ucgui高版本源码啦。有兴趣的可以下载试试，本人尚未测试 -ucgui V3.98 is currently the network relatively new version of source ucgui high啦. Are interested can download a try, I have not yet tested

本程序又是一个单片机的简单例程，含电路图及C程序，可参考-This procedure is a simple and routine single-chip, including circuit diagrams and C procedures, can be found! !

16c552驱动程序，两个穿口+1个并口的驱动程序-16c552 driver, two I wear a parallel port drivers

OCM4X8C液晶显示在凌阳单片机上的驱动程序-OCM4X8C in Sunplus LCD Single Chip Driver

利用MEGA8同时控制四路分立的单总线设备TH-11数字湿温度传感器，并根据查找表反推出传感器电阻值，显示在LCD12864显示器上。公司内部用机器。-MEGA8 simultaneously control the use of four separate single-bus devices TH-11 digital wet temperature sensor and, based on look-up table against introduction of sensor resistance value, displayed in the LCD12864 display. Within the company with the test machine.

/// ////差动输入，定时启动，由T2定时//////////////// /////////选择6，7通道为ADC0差动转化通道,其中第6通道为P3.6,第7通道为P.7-/////// Differential input, time to start, from time to time T2 ///////////////////////// choose 6,7 for ADC0 channel difference Dynamic conversion channel, the first of which for the 6-channel P3.6, No. 7 channel for P.7

用汇编语言编写的6位8段数码管显示程序与MS-51单片机实验系统配合使用-assembly language prepared by six of eight digital control display program with the MS-51 used in conjunction with experimental system

51单片机操作89F0X0系列FLASH存储器的程序-51 89F0X0 Series MCU operating procedures FLASH memory

基于proteus的指针式温度计的源码，伺服电机驱动-Based on the Proteus of the source pointer thermometer, servo motor drive