99的计数器，使用AVR128单片机制作，从0开始记数到99自动清0，用数码管显示...

C8051F040 t3可调频率方波输出例程-C8051F040 adjustable frequency square-wave output routines

lcd12864不带字库 实现画线 画点 正弦曲线 很好的例子 绝对不后悔-lcd12864 without drawing a line drawing point font to achieve a good example of the sine curve is absolutely no regret

MSP-FET430X110 C语言例子程序-MSP-FET430X110 C language examples procedures

c语言实现的16分钟录音芯片ISD4004的操作源程序。可以参考一下-c language of the 16-minute recording chip ISD4004 operation source. Can reference

这是本关于学习KEIL软件使用方法的书，是PDF格式，请确认你安装了该软件才可阅读-This is the KEIL on learning how to use software, is in PDF format, please make sure you install the software before reading

430读写IIC总线以及中断控制程序-430 literacy IIC bus and interrupt control procedures

计算机简单控制由软件和硬件组成。软件由Visual Basic 6.0编写。硬件主要由无线发送模块和单片机（C语言编写）构成。通过RS232界面与PC通信而实现无线控制系统。 主要功能是：通过遥控器连接PC机的"上下左右"按键 ,当电脑界面处于powerpoint界面下,能通过遥控器控制幻灯片的上下切换. -Simple control by the computer software and hardware components. Software prepared by the Visual Basic 6.0. Hardware mainly by the wireless sending module and single chip (C language) constitute. Through the RS232 communication interface with the PC wireless control system. Main function is to: Connect PC through a remote control machine up and down about button, when the computer interface in a powerpoint interface via remote control to switch slides up and down.

mcu_PPP.rar是在M68HC08单片机上编写的TCP/IP协议程序.实现了SLIP、PPP、ICMP、UDP、TCP网络协议。 -M68HC08 Singlechip mcu_PPP.rar is prepared on TCP/IP protocol procedures. realize a SLIP, PPP, ICMP, UDP, TCP network protocol.

基于C8051F020单片机的LCD显示程序，LCD用的是320×240屏幕，驱动芯片为SED1330，采用C51编写-C8051F020 LCD display program, using the LCD 320 x 240 screen, driver chips for SED1330, prepared using C51

16位按键扫描程序,包含数字钟计时,闹钟报警,及定时应用-16 button scanning procedures, including digital clock timer, alarm clock, alarm, and timing applications