19264时间控制 画图功能

PC 通过串口工具在发送节点A 端输入想要发送的数据，点击发送，在接收节点B 端 PC 上的串口工具上，可以看到节点B 收到的内容。如要发送10 个字节内容为11 22 33 44 55 66 77 88 99 AA 的数据/时，在发送节点A 端的串口工具上输入 0A 11 22 33 44 55 66 77 88 99AA，其中0A 代表要发送数据的长度，以16 进制表示。在接收节点B 端的串口工具上就可以收到相应的数据。-PC through the serial port tool sending node A wants to send data from client input, click on send, at the receiving node B-side on a PC serial port tools, you can see the node B received. If you want to send 10 bytes of content 11 22 33 44 55 66 77 88 99 AA of the data/pm at the sending node A on the input side of serial port tools 0A 11 22 33 44 55 66 77 88 99AA, in which you want to send on behalf 0A the data length to 16 hexadecimal said. Node B at the receiving end of the tool on the serial port can receive the corresponding data.

bu shi hen hao bao han yi xia-hen hao bu shi yi xia Jane han

8051驱动320*240LCD程序 用汇编编写-8051 driver 320* 240LCD procedures used to prepare the compilation of

msp430单片机控制完全时钟程序,这个程序太好用了,欢迎高手来交流-MSP430 single chip microcomputer to control fully clock procedures, which spent too good to welcome you to share

RF24L01驱动程序---C51-RF24L01 driver--- C51

非常好的VHDL用于LCD显示的程序，改下就能够使用了的-VHDL very good procedures for the LCD display, to be able to used under the

OCM4X8C液晶显示在凌阳单片机上的驱动程序-OCM4X8C in Sunplus LCD Single Chip Driver

单一灯的左移右移分别接在单片机的P1.0－P1.7接口上，输出“0”时，发光二极管亮，开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮，重复循环-A single light, respectively, shifted to right then left at P1.0-P1.7 microcontroller interface, the output " 0" when the bright light-emitting diode, the beginning of P1.0 → P1.1 → P1.2 → P1. 3 → ┅ → P1.7 → P1.6 → ┅ → P1.0 Liang, repeat cycle

stc单片机IAP源码,可将数据写入单片机内部FLASH中,无须外扩FLASH,速度快-stc IAP source SCM, data can be written into the internal FLASH MCU, FLASH without foreign expansion, speed