单片机操作EEPROM 240X的程序。 非原创，转载。

LT_1B msp430开发板例子程序－Clock Out

基于凌阳GPCE061板，由C和汇编嵌套组成的MXIC串行flash驱动程序。-Based on Sunplus GPCE061 board, from C and assembler comprising nested MXIC serial flash driver.

基于LM3S3748的3.2TFT手写板程序-The LM3S3748-based tablet program 3.2TFT

以

crc计算方法之一，适合于有较大ROM或外部存储器的单片机-unicef.org calculation method, one more suitable for external memory or ROM Microcontroller

AT89S52串口多字节接收,可以接收任意字节.-AT89S52 serial multi-byte reception, can receive any bytes.

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

利用单片机以及DA0832产生正弦波的C51源程序-As well as the use of single-chip generated sine wave DA0832 source of C51

基于MipsCPU的UART通讯程序，在u-boot下运行。-MipsCPU based on the UART communication procedures, in the u-boot run.

低成本m48+热敏电阻做多路温度报警装置显示和音乐！