MSP430F20xx the C language development paradigm, including the timer example, co...

：章介绍了数据采集系统中STC12系列单片机与PC机之间的串行通信。设计了sTc12c2052AD 与 MAX232的硬件电路，使用汇编语言编程，设置了串行1：7的工作方式，相应的波特率计算方法及特点，发送并接 收数据。单片机从EEPROM 中读取数据，通过R．S-232将其传入PC，并将数据存储在24C02中。-: Chapter introduces data acquisition system STC12 Series MCU and PC serial communication between machines. Designed sTc12c2052AD with MAX232 hardware circuit, the use of assembly language programming, set up the way the work of serial 1:7, the corresponding baud rate calculation method and the characteristics of sending and receiving data. Single-chip EEPROM read data from, by R. S-232 to incoming PC, and data storage in the 24C02.

NE5532+TDA2030 原理图及PCB-NE5532+ TDA2030 Schematic and PCB

利用avr c编程并实现了proteus模拟，可作为avr的绝好学习例程-Avr c programming and the use of the Proteus realize simulation, can be used as an excellent learning routines avr

atmega32 和RS485的通讯，已经在电路板上测试通过，RS232相对简单一点，RS485需要对控制收发信号处理一下，并且需要RS232转RS485工具来验证收发是否正确-atmega32 and RS485 communication, has been tested in the circuit board, RS232 relatively simple point, RS485 transceiver control signals need to deal with you, and will need RS232 to RS485 transceiver tools to verify the correctness of

c51串口通信程序-C51 Serial Communication Program

CAN上位机通讯程序vb与单片机通信时用的上位机程序 -CAN PC communication program vb and MCU communication procedures used in PC

单片机IDE3000的指导手册，第二版，内含指令集和集成环境的使用方法-SCM IDE3000 instruction manuals, the 2nd edition, containing instruction set and integrated use of the environment

有单片机控制的12864图形显示程序，，有汉字和图形的程序-There are 12,864 single-chip graphic display control procedures, there are Chinese characters and graphics procedures

基于MSP430单片机的1602液晶驱动子程序 使用时首调用初始化，然后就可以写指令和数据了。内含文档及注释。-Based on MSP430 MCU 1602 LCD Driver Subroutine used to initialize the first call, and then be able to write instructions and data. Containing documents and notes.

ili9325TFT彩屏驱动器初始化源码-color ili9325TFT drive initialization source