AT89C51和ADC0808 8路模式切换到显示电路的数字关系的数量

VX1818驱动AU 7"屏的源程序，公司已量产了。提供给大家参考。-VX1818 driver AU 7

转化为控制指令，然后每50ms通过串口向上位机发送一次命令，上位机收到数据后控制虚拟仿真机器人，最后，上位机收集虚拟机器人的姿态参数，再通过串-Translated into control commands, and then every 50ms upward through the serial-bit machine to send a command, the data received after the host computer to control the virtual simulation robot, finally, the collection of Virtual PC robot posture parameters, and then through the string

很小很弱的51单片机的四字节BCD码转换程序不过很多课堂练习可以参考-very weak 51 SCM four byte BCD conversion but many can refer to classroom exercises

用单片机与CPLD做的等精度频率计，误差精确到十亿分之一-MCU and CPLD make use of such precision frequency meter, the error is accurate to a billionth of a

电动机的单片机控制-Motor MCU control

单片机的24C02读写程序,使用Keil c编译器测试正常。-the 24C02 microcontroller literacy, the use of Keil c compiler tests are normal.

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures

C8051F120初始化SPI，启动CC2420。通过将CC2420 得VREG_EN 引脚置位高电平使能Voltage regulator，等待其稳定；然后重新启动CC2420 芯片，等待晶振起振。-Initialize SPI, start the CC2420. By CC2420 have VREG_EN pin high to enable the set Voltage regulator, waiting for their stability and then re-start the CC2420 chip, since waiting for crystal oscillator.

温度控制的程序，自动调节蒸汽开度阀和风机的运行，来达到控制温度的要求-Temperature control program, automatically adjusts the output temperature control

5045的c语言读写程序，经过验证，可以直接使用-5045 of the c language to read and write process, after authentication, direct access to