用单片机控制红外编码探测障碍物。本文提出解决干扰的方案是：由单片机控制发射有一定意义的红外编码脉冲串，同时，单片机接收该脉冲串。如果接收到的信号和发射的信号基本...

51驱动RA8835/SED1335的320*240的液晶驱动程序-use 51 to driver LCD display in scale 320*240 with RA8835/SED1335

16x16LED 点阵屏源代码和电路图，可以实现上下移，左右移-Dot-matrix screen 16x16LED source code and schematics can be achieved on the lower left and right shift

单片机测速 用测频的方法测速，用于简单的环境 已调试程序-MCU speed by the method of frequency measurement speed, for a simple debugger environment has been

基于ARM7的U盘程序开发代码,可以-ARM7-based U-procedure code, can see the

单片机C51串口接收（中断）和发送例程，可以用来测试51单片机的中断接收 -80C51 Serial reception (suspended) and send routines can be used to test 51 SCM interrupt reception

我用单片机8952和电压比较器339做了一个简单的电容容量测量表，参数大 致如下： 电容测量范围为1pF-9999.99uF，最小分辨力为1pF。分为5个量程，可以自 动切换量程，也可手动切换。 另外，有简单的频率计功能，能测量0-60MHz的数字信号频率（TTL电平）； 还可以产生几个单点频率的方波信号（比如1KHz）。 采用1602LCD作为显示器；4个按键控制；使用24C01保存当前设置值，不用 每次开机重新设置。可单5V供电，也可9V交流供电 -I used the single-chip 8952 and the voltage comparator 339 to do a simple capacitance measurement table, parameters are as follows: capacitance measurement range 1pF-9999.99uF, the minimum resolution for the 1pF. Divided into five ranges, you can automatically switch range can also be manually switched. In addition, a simple frequency meter function, capable of measuring 0-60MHz frequency digital signal (TTL level) can also lead to several single-point-frequency square-wave signal (for example, 1KHz). 1602LCD used as a monitor 4 button control use 24C01 to preserve the current settings, do not reset each boot. Can be a single 5V power supply, 9V AC power supply can also be

4*4数字键盘输入温度极限值，DS18B20测温，数码管显示温度值，蜂鸣器和LED报警-4* 4 digital keyboard input temperature limit, DS18B20 temperature measurement, digital display temperature control, alarm buzzer and LED

AVR控制SD卡或MMC卡的程序 调试通过-AVR control the SD card or MMC card through the program debugging

《msp430应用系统开发典型实例》第9章程序代码- Msp430 typical examples of application systems development, Chapter 9 code

MSP430的C语言集合，集合各模块的使用范例-C for msp430