本程序的开发环境是VC++,实现的功能是串口通信.

串口通信，写成dll便于参阅-serial communication, written dll ease of reference

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

vbnet与232通讯，对于用VB.NET开发串口程序有帮助-vbnet communications with 232 for using VB.NET Serial procedures help

一个很实用的串口调试软件，需要设置的变量很少。-a very practical serial debugging software, the need for a few variables.

本代码是VC源代码，实现通过串口接收和发送短消息。-VC code is the source code to achieve through the serial port to receive and send short message.

这是我自己写的,请各位高手看一下!!是关于串口方面的编程,用java-This is what I wrote it myself, please look at the top! ! Serial on the program, using java

这是一个串口监视程序，能够很好的调试串口并监视串口数据。-This is a serial surveillance procedures to good serial debugging and monitoring serial data.

串行通信的（源代码）做maxplusII

关于RS-232 RS-485串口通信的详细资料-On the RS-232 RS-485 serial communication of detailed information

介绍了如何用verilog语言实现处理器部件uart-Describes how to use Verilog language processor components UART