RS232控制软件

一款优秀的串口监视工具-a perfect serial supervising tool

串口通信的东东 串口通信的东东串口通信的-Dongdong serial communications serial communications serial communications Dongdong

RS232串口通信编程 -RS232 serial communication programming

实时串口操作动态库,dll的形式实现了串口实时操作-dynamic real-time operation of the serial, dll in the form of a serial real-time operation

最初学习写单片机串口通讯时的源程序，可以让初学者参考一下！-first learn microcontroller serial communications at the source, so that beginners can take a look!

Visual C++串口通信技术与工程实践 随书带的源码-Visual C++ Serial communications technology and engineering practice with the book

SPCE061A 利用C语言进行软件端口位操作范例-SPCE061A C language for the use of port-operating software paradigm

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

一个通讯的主站程序 献给vc 串口通信的网友 看看吧-a communications major stations dedicated to the vc serial communication netizens watch it

用于和远程modem建立连接，发送字符信息的串口通信软件-And the remote modem for establishing a connection, sending the characters of the serial communication software information