3.CB_seri.cpp(C++Builder串行异步通信程序)

这是对应于atmel公司的24cxx的驱动程序，仅供参考！-This is corresponding to the ATMEL 24cxx driver for reference!

rc522DEMO带串口通信，可用于参考设计，带有调试软件-rc522DEMO with serial communication, can be used for reference design, with debugging software

用VC实现的串口调试软件-with VC serial debugging software

yon用硬件描述语言写的曼彻斯特编解码,并在Xilinx CPLD上的实现,内容齐全,是学习的好资料-yon hardware description language used to write the Manchester encoding and decoding Xilinx CPLD and the realization that the complete study is a good information

这是一个改进了的串口RS232的类，它能有效的防止空间泄漏，通过这个类可以开发串口通信。-This is an improvement of a RS232 serial port class, it can effectively prevent the leakage space, can be developed through this type of serial communication.

串行数据标准选用之我见 RS-232、RS-422与RS-485标准及应用 转换器的构成 -Selection of serial data standards, I see the RS-232, RS-422 and RS-485 standards and the application of the composition of converter

使用IC卡发卡机构的预付费PB VF BCB DELPHI VC源程序，对其进行了详细说明

一个串口通信的源码，以2进制形式实现传输，可以传输图像等各种文件。-a serial communication source to the form of two-band transmission, transfer images and other documents.

这是一个串口通信的实例。 里面用到很多控件，对于初学者值得学习！-This is an example of serial communication. Which used a lot of control, for beginners to learn!

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.