bin转换为hex格式的小软件。用于某些特定的编程器。

单片机实验：定时/记数器8253。的原程序代码，ASM文件。-SCM Experiment : Timing/Register 8253. The original code, ASM file.

利用Verilig编写CPLD读写EEPROM（74LC21）程序-Verilig prepared to use CPLD to read and write EEPROM (74LC21) procedures

单片机与LCD12864并口控制驱动程序-SCM and LCD12864 parallel port control driver

基于51系列单片机的串口通信测试程序，希望对大家有帮助-Based on 51 Series Single-chip serial communications test program, and they hope to have everyone help

在Atmega16上实现 一位的计数器 键盘输入 数码管显示 -ATmega16 achieved in a digital keyboard input of the counter display

通过不同的二极管亮，表示洗衣机的不同状态。如正转、反转、洗条、干衣。按下P3_3时，会停止。 -through different diode light, washing machines, said the different states. Who is changed, and turned around, washing, drying. Press P3_3, would cease.

驱动显示屏硬件的栅和段的位数，控制16312的四个输出口数据。-Hardware display driver section of the gate and the median of the four control output 16312 data.

源程序51与PC通信原理及实现.rar-source 51 and PC Communication Theory and Implementation. Rar

功能： 1、作为下位机采集8255数据并将此数据通过通讯送出， 2、采集数据为BCD，先转换成二进制，处理后再转换成BCD 3、通讯采用方式3，多机通讯，上位机发地址时TB8=1，其他TB8=0 下位机SM2=1，RB8=1时产生中断后使SM2=0收发数据，结束后SM2=1-Features: 1, as under the 8255-bit machine data collection and communications sent through this data, 2, collected data for the BCD, first converted into binary, and then converted to deal with BCD 3, communication using methods 3, multi-machine communication, PC-fat address TB8 = 1, other TB8 = 0 under the digital machine SM2 = 1, RB8 = 1 when the failure to make SM2 = 0 to send and receive data, after the end of SM2 = 1

键盘扫描LED驱动芯片ch451资料及c语言源代码-keyboard scan LED driver chip ch451 information and c language source code