AVR单片机的RS232通信演示程序，采用八兆晶振的传输字符串函数。...

用keil c编写12864LCD驱动程序,并用ISIS软件仿真实际效果-Keil c prepared with 12864LCD driver, and the actual results ISIS software simulation

飞思卡尔xs128 PWM直流电机驱动-freescale xs128 PWM driver for DC-motor it s easy only for freshman!!!!

USB转串口的VC原代码,CH372连接单片机和计算机，起转接USB作用-USB to serial port of the original VC code, CH372 Singlechip and computer connectivity, USB adapter from the role of

MCS-51单片机实用子程序库,对十进制浮点数和二进制浮点数的相互转换子程序进行了彻底改写，提高了运算精度和可靠性-MCS-51 single-chip utility subroutine library for floating point and binary floating-point decimal mutual conversion subroutine carried out a thorough rewrite, improve the computing accuracy and reliability

LA1823+LC72131收音机子程序.-LA1823+ LC72131 Radio subroutine.

是用51单片机检测色度色差的算法和具体实现的代码-is 51 Single-color and color algorithm to achieve specific code

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

PIC单片机模拟SPI口-PIC simulation SPI mouth

用C语言读写CF卡程序 非常不错的东西-Used C language literacy CF card procedures very good things

jg162gLCD显示器的资料和C驱动源码-jg162gLCD display information source and C Drive