12,14,16点阵汉字显示文件 12,14,16点阵汉字显示文件

ABB AIN电表读多类数据通讯测试程序，包括数据类9、11、14、15等。-ABB AIN meter reading more categories of data communications test procedures, including data types, such as 9,11,14,15.

plcfx VB开发的串口与三菱PLC通讯源码，超值，搞工控的朋友-plcfx VB Serial communication with the source of Mitsubishi PLC, Value and engage a look at the IPC

UART_verilog,自己设计的异步串行收发。包括测试文件。-UART_verilog, designed to send and receive asynchronous serial. Including the test file.

一个很实用的串口调试软件，需要设置的变量很少。-a very practical serial debugging software, the need for a few variables.

本程序是win32api串口编程tty(虚拟终端)实例包括硬件控制的设置,因此可以用于对modem的编程-win32api Serial Programming tty (virtual terminals) Examples include control of the hardware installed, the modem can be used for programming

MCU读写U盘源程序（无需子程序库基于文件系统）, MCU读写U盘源程序（无需子程序库基于文件系统）-MCU literacy U-source (without subroutine library based on the file system), MCU literacy U-source (without subroutine library based on the file system)

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

本人自己用Delphi做的串口测试程序，有助于学习如何通过串口收发数据-my own use Delphi to do serial testing procedures and facilitate learning through the serial data transceiver

通过USB接口利用多媒体进行数据采集的源程序，通过调试的。-through the USB interface for multimedia data acquisition of the source, through the debugger.

usb通讯程序，用c语言实现，简单易懂,看完以后马上就能写出你自己的程序-USB program,c language realization,