Serial debugging assistant to support a variety of data conversion, but also to...

控制X射线和高压源的典型应用程序，包括经典的串口数据处理。-Control the source of X-rays and a typical high-pressure applications, including the classic serial data processing.

基于对话框的串口通信，三种方法中的利用添加控件的方法实现通信-Dialog-based serial communications, the use of three methods to add control methods to achieve communication

MSComm32.ocx串口通信程序。测试时不要用虚拟串口，直接将串口2引脚与3引脚短接。-MSComm32.ocx serial communication program. Not to test with virtual serial port, serial port directly to 2-pin and 3 pin shorted.

研华da采集例程-Advantech da collection routines

西门子300的一个程序。是和HMI（WINCC）集成的一个程序-Siemens 300 a procedure. Is HMI (WINCC) integration of a program

串口扫描程序,能够边扫描边进行数据的判断-serial scanning procedures can-while-scan data judgment

单片机通用串口uart接收与发送无线信息，实现无线接收。-MCU Universal Serial uart receive and transmit a wireless message, wireless receiver.

通讯类程序,serialport串口通讯源代码-servail

本程序是i2c总线读写一个字节的程序。在写过程序中，不一定非要检测i2c的应答位，可以直接延时过去就行，但是在读过程中必须给应答信号，读完发停止位，一定确认所发的信号都发上了。否则在连续地址读的过程中可能不会出错，但是在随机度过程中就会出错，我的程序就是在给停止信号时没有给上，24cxx一直在输出数据，结果读出错。找着问题后我的程序只加入了一条命令便完全正常。-i2c bus read and write a byte procedures. The written procedure, not necessarily require the detection i2c-response, and can directly past trip delay, but the process must be read to the response signal, stopped at reading, we recognize the signals are on the fat. Otherwise, the address read for the course could not go wrong, but the randomness of the process would be a mistake, I was in the process to stop for no signal, 24cxx in output data, read errors. I discovered the problem after the procedure just joined the order of a completely normal.

为什么传一个文件都这么烦了,人都傻了!为什么传一个文件都这么烦了,人都傻了!-Why is a mass of documents are so annoying, people are stupid! Why Chuan a file are so annoying, people are stupid!