这是我对FPGA程序的VME总线接口的设计，对FPGA的一面…

一个简单的23计数器，用VHDL实现，可供初学者学习。(A simple 23 counters, with the VHDL implementation, available for beginners.)

基于labview的数据采集系统，包括示波器和函数信号发生器，可以实现简单数据采集.(Labview-based data acquisition system, including oscilloscopes and function signal generator, can achieve a simple data acquisition.)

控制步进电机转动，正反转，旋转角度完美掌握。很好用，亲测(Control stepping motor rotation, positive and negative rotation, perfect control of rotation angle. Very easy to use, personal test)

FIFo参考设计16x32 FIFO with simultaneous read/write operations.-FIFO design-16x32 FIFO with simultaneous read/write operations.

采用Verilog HDL设计，在Altera EP1S10S780C6开发板上实现 选取6MHz为基准频率，演奏的是梁祝乐曲 - Uses Verilog the HDL design, development board realizes in Altera on the EP1S10S780C6 selects 6MHz is the datum frequency, the performance is Liang wishes the music

说明：  fft代码,采用蝶形算法,包括C,matlab和verilog代码(fft code, using butterfly algorithm, including C, matlab and Verilog code)

说明：  通过一个计数器来实现输出信号的占空比要求，可以将duty_cycle分配到拨码开关上,LED分配到发光二极管上,然后调节拨码开关,即可看到LED的亮度发生变化.(The duty cycle of the output signal can be assigned to the dial switch by a counter, and the LED can be assigned to the light emitting diode. Then the brightness of the LED can be seen by adjusting the dial switch.)

脉动乘法器：一个GF(2m)域上的Digit-Serial 脉动结构（Systolic）的乘法器(Pulse Multiplier: a GF (2m) domain on the Digit-Serial pulsation structure (Systolic) the multiplier)

介绍了基于Altera 公司的CPLD 芯片FL EX10 K,以及利用VHDL 语言实现多位二进 制码转换成8421BCD 码的原理、设计思路和软件实现。-Introduction based on Altera

tlm基本框架，生产消费模型例子 tlm基本框架，生产消费模型例子 tlm基本框架，生产消费模型例子(tlm basic framework, examples of production and consumption model)