Introduction of the I2C interface package that the source code and software pack...

这是飞凌TE2410开发板的Bootloader源程序。-This is a development board飞凌TE2410 of Bootloader source.

在s3c2440开发板裸板上模拟软中断处理程序，处理程序中是对LED灯的控制。-Development board in the bare board s3c2440 simulation soft interrupt handling procedures, the processing procedure is the control of LED lights.

基于LPC2XXX系列,用ISP1161作USB HOST的驱动程序.-Based on LPC2XXX series, with ISP1161 as USB HOST driver.

arm2410板支持nand启动的开发详细过程-arm2410 board to support the development of detailed process to start nand

触摸屏，代码中以c语言为编程语言，以STM32为硬件支撑mcu，stm32f10x_crc.c，ili9320.c，关于2.8寸屏和3.2寸屏的触摸屏配置：如果使用的是2.8寸屏的触摸屏，请修改“ARMJISHU_TouchScreen_ADS7843.h”中起始出的宏定义如下

LPC2300系列的ARM7单片机上FAT文件系统源代码，对开发文件系统很有帮助！-LPC2300 family of ARM7 single-chip on the FAT file system source code, file system on the development of very helpful!

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

电压和电流的测量程序,这是个很典型的应用,通过这个很实用-Voltage and current measurement procedures, this is a very typical applications, the adoption of this very practical

单片机实现的超声波测量距离的例程。测量得到的距离值分别可以再液晶屏上显示和数码管上进行显示。

flash烧写器，支持WRIGGLER和SDT的JTAG(运行时可自动选择)-burning flash devices, and support WRIGGLER SDT JTAG (runtime can automatically select)