Development board in the bare board s3c2440 simulation soft interrupt handling p...

uCOS移植范例,开发人员或嵌入式爱好者可以借鉴。-uCOS transplantation example, developers or embedded lovers can learn from.

s3c2410，MDK下面RFID例程实验，可以实现通过串口读取RFID卡ID号并显示出来。-s3c2410, MDK following routine experimental RFID can be achieved through the serial port to read RFID card ID number and displayed.

adhoc信息节点程序源代码（点对多点）――for atmega128-ADHOC information source code node (point-to-multipoint)- for atmega128

基于arm7芯片s3c44b0x的拼音输入法-Based on the ARM7 chip S3C44B0X pinyin input method

这是只是一个示例项目，通过使用 Keil µVision 4、 xx 和 MDK 4.72 ； 写在"C"SSD1963 3.5"TFT 显示屏 （HY35A） 是如何编程和加入通过 FSMC 总线。

μCOSⅡ在ARM处理器上的移植μCOSⅡ在ARM处理器上的移植

Efficient C programming techniques for ARM Architecture.

进行arm－linux嵌入式系统开发时，需要将文件烧写到flash上，在网上可以找到win下的烧写程序，但多数情况下开发环境应该是在linux下，烧写程序时切换到win下很不方便，使用该程序可以在linux下直接对flash进行烧写 该程序运行后将一个小的for arm的c程序通过串口传送到arm开发板上，使用该小程序与主机端通信，将主机传送信息烧写到flash上- Carries on when arm- linux inserts the type system development, needs the document fever to write on flash, is on-line may find under win the fever to write the procedure, but in the most situations the development environment should be under linux, the fever writes when the procedure cuts under win not to be very convenient, uses this procedure to be allowed directly to carry on the fever under linux after flash to write this procedure movement to transmit orally a small for arm c procedure through the string delivers on the arm development board, uses this script and the main engine end correspondence, writes the main engine pass-along message pam fever on flash

周立功的arm7源码－－－－好东西，一般的起始代码范例，觉得不错，推荐一下-weeks meritorious arm7 source-good things, the general initial code examples, think it"s good, what recommendation

AT91RM9200的异步串口调试程序,波特率为1152-AT91RM9200 serial asynchronous debugger, the baud rate for 1152