ATmega16L基本ADC程序，使用PA0到PA7在显示数据…

ppp协议的功能实现部分,为了成功测试简化了部分代码. 可在keilc7.0上编译通过. 最初的代码是在摩托罗拉的68上实现的.-ppp function realization of the agreement, in order to successfully test simplified some code. In keilc7.0 compiled through. The original code is in Motorola"s 68 on the case.

该程序实现了LCD1602在AVR单片机上控制，详细定义了各种功能函数，并自定义了汉字库-The program achieved LCD1602 Singlechip in AVR control, detailed definitions of the various features function, and customize the汉字库

新手关于单片机的-newcomers on the MCU

51单片机与USB芯片PDIUSBD12接口固件程序,来源于周立功单片机-51 MCU with USB interface chip PDIUSBD12 firmware procedures, Zhou, who comes from SCM

学习的例程！和通用的LCD1602的有区别，对比来学！-learning routines! GM and the LCD1602 the distinction, compared to school!

st7565驱动LCD12864源代码以及经调试通过的LCD测试程序-st7565-driven debugging LCD12864 source code, and adopted by the LCD test program

这是f040与2401连接后，进行通信的程序。已经调试通过了 仅供大家参考 第一次传 不好的习惯请大家指正 -This is connected with the 2401, the communications procedures. Debugging has been adopted only refer to the first-bad habit of correcting Thank you, please

采用dspic30f2010的变频器核心驱动程序,程序可以实现正转/反转,频率设定,保护等-the inverter used dspic30f2010 core drivers, procedures can be achieved is to/inversion, frequency creation, protection

本程序是在c51低下的菜单程序。 如果要mcu 低下编写菜单的朋友可以拿来参考.-the procedures in the lower menu decoder procedures. If the lower mcu prepared menu can be used to reference a friend.

atmel官方的sam7x256芯片在keil编译环境下的全部源代码，以工程形式提供。-official sam7x256 atmel chip keil build environment in the whole of the source code, As for the form.