atmel官方的sam7x256芯片在keil编译环境下的全部源代码，以工程形式提供。...

麦迪工作室51开发板LCM1602液晶屏驱动代码。可点亮1602液晶屏。-Madison Studio 51 development board LCM1602 LCD driver code. 1602 LCD screen can be lit.

X5045的读写应用程序，经过测试，完全能用-X5045 reading and writing applications, tested and fully use

This version of the code is compatible only with the AT89C2051 due to the location of the data buffer and stack in RAM. The code may be modified to work with the AT89C1051 by relocating or resizing the buffer and stack to fit into the smaller amount of RAM available in the AT89C1051.

单片机网络教程，很好的基础教程。详细讲解了从硬件开发到软件开发须掌握的基础。-Single-chip network tutorial, a very good basis for tutorials. Detailed account of the development from hardware to software development required to master the foundation.

x5045的程序，可以在keil c51上运行，希望能给大家带来帮助-X5045 procedures keil c51 can run, I hope everyone can help

编程爱好者，自编C程序跑灯，控制单片机P1口，逐个点亮心中的明灯-Programming enthusiasts, self-compiled C program running lights, control Singlechip P1 mouth, one by one lit the hearts of the light

座机短信发送平台，LCM显示发送和接受号码显示源程序。LCM1206类型-jet sent SMS platform, LCM revealed sending and receiving numbers indicate the source. LCM1206 types

这是一个，51单片机的脉冲采集器的程序，可以用KEIL C环境下编译，也可以使用WAVE软件，运行非常稳定-This is one of 51 single-chip pulse collector procedures, can be used KEIL C compiler environment, you can also use WAVE software, to run very stable

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.

步进电机控制,LCD显示-Stepper motor control, LCD display