控制LED灯的亮灭 控制LED灯的定时亮灭，单片机定时器的使用。...

学习51单片机必备的一些C语言基础知识，对C语言不熟悉的朋友会有一定的帮助-51 Singlechip necessary to learn some basic knowledge of C language, on the C language are not familiar with our friends will help

led跑马灯显示，实现一秒钟闪一次。基础性的代码，比较简单。-led display

工业开关量检测模块的原代码,带断线检测功能-Industrial switch module testing the original code, with disconnection detection

Dallas 单片机源代码 用与DS89c390-Dallas SCM source code using DS89c390

atmel的atmega128外扩ram对液晶的驱动调试程序，已经使用。-ATMEL expansion outside the atmega128 ram right LCD driver testing procedures already in use.

使用微芯公司的PIC18F458单片机，用C语言实现两块单片机之间的CAN通讯，包括接收和发送数据。-The use of Microchip

周立功 lpc2104 开发板资料和测试程序，经过调试-weeks meritorious lpc2104 development board information and testing procedures, after debugging

本程序为应用在Arm7下的Ps2键盘接口程序。避免了因多中断而数据出现错误的情况-This procedure is used in ARM7 under the Ps2 keyboard interface program. To avoid interruption caused by more than the case of data error

cf8020+cp2200(网络)的驱动实现-cf8020+ cp2200 (network) drivers realize

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.