很好的东西

这是一个单片机上控制MAX7219的驱动子程序，用C语言编写。-This is a single-chip control MAX7219 driver subroutine, using C language.

该程序为t6963控制器的c语言驱动程序，内有proteus的模拟仿真图形，是单片机学习的好例程！-procedures for the t6963 Controller c language driver, proteus within the simulation, graphics, SCM is a good learning routines!

时钟芯片PCF8563的51单片机程序 时钟不超过12MHZ，本程序已在51上试过，可以用-PCF8563 clock chip clock of 51 single-chip program does not exceed 12MHZ, this procedure has been tried in the 51

电压表仪器测量，实现用VC++调试而成的仪器电压表-The source project is developed with Visual C++6.0, and works for Volt Meter instrument.

是avrfreaks上的一个DS1302的例子，我把它和HD44780结合起来用Proteus仿真 仿真环境：Proteus sp5 编程环境：winavr -avrfreaks is one of the DS1302 example, I put it on HD44780 combined with Proteus simulation simulation environment : Proteus sp5 programming environment : winavr

AD中断服务程序,介绍了中断的利用和编程技巧-AD interrupted service procedures, introduced a suspension of the use and programming skills

this is a sensorless fan motor control code .(it use the angle-ahead commutate tech.)

单片机控制步进驱动，S1为启动，S2为停止，S3为加一，S4为减一-Single-chip stepper drive control, S1 for the launch, S2 to stop, S3 for the plus-one, S4 for by one

常用串行EEPROM的编程应用，SPI总线(Serial Peripheral Interface串行外围设备接口总线)是三线式的串行总线，是由摩托罗拉公司所研发，使用三线进行数据传输，分别是SCK时钟引脚，SI数据输入引脚和SO数据输出引脚。-Commonly used application of serial EEPROM programming, SPI bus (Serial Peripheral Interface Serial Peripheral Interface Bus) is a three wire serial bus is developed by Motorola, the use of third-line data transmission, namely the SCK clock pin, SI data input pin and the SO data output pin.

1602A 显示的英文句子。实验板上已通过-1602A