这是一个用汇编写的8051单片机系统的小车避障程序，是用红外发射和接收的方式，并结合了proteus 6.7，相信对初学者有所帮助...

介绍msp430的c语言编程，有很多例子，通俗易懂，很适合初学者-MSP430 introduction of the c language programming, there are many examples of user-friendly, it is suitable for beginners

实现基于PIC25j10单片机，实现对HSM－20G温湿度模块，对换境数据的采集，给压缩包包含了所用到芯片的DATASHEET以及原代码-PIC25j10-based microcontroller, the realization of HSM-20G module temperature and humidity on the Habitat for data collection, to the compressed packet contains the chip DATASHEET used, as well as the original code

ateml 10位AD 通用程序-ateml 10 AD common procedures

winavr环境下的一段与pc机进行通讯的程序，可供参考。-winavr environment for some pc machine to communicate with the procedures for reference.

mcu:78p156 driver: control w55p241(winbond) with spi

基于单片机的推挽型逆变器控制系统设计及其程序设计 SA838初始化及控制子程序 ADC0809的控制及数据处理子程序 数据处理及电压显示子程序-MCU-based push-pull type inverter control system design and programming SA838 Subroutine to initialize and control the ADC0809 data processing control and data-processing subroutine and voltage display subroutine

用CY7c6300驱动LED的源程序,经过验证,绝对能用P0口LED到VCC就可以.-with CY7c6300 drive LED source, proven, I absolutely can use P0 LED VCC to be.

CC1100射频电路的线路板和已经调通的源码-CC1100 RF circuit and the circuit board s source code has been transferred

这是DSP2407的RAM测试程序,含全部源码,调试通过,可运行.-This is the DSP2407 the RAM test procedures, including all source code, debugging is passed, can be run.

以上程序使用PIC12C508单片机，内部4MHZ时钟，4脚输入50HZ脉冲信号，7，6，3脚（GP0，GP1，GP4端口）为输出口。其中渐变部分是让灯慢慢的变亮（或灭--It uses PIC2C508 SCM, 4MHZ clock, 4 port is for inputting 50HZ signal, 7/6/3 port for output.