里面是单片机的开发板的源程序，包括AD，DA转换，数码管显示，按键的识别，液晶的显示是、数据存储，等等 还有开发板配套的原理图和PCB图纸，让你看整个程序更容易...

上位机与单片机之间的通信,非常的容易,看了你也便会!-PC and communication between the microcontroller, very easy to read you will!

使用PIC12C508509的例程：用PIC12C508509 控制一个步进电机源程序，用PIC12C508A 控制模型源程序和用PIC12C509 控制LED。-an example program about PIC12C508509: use PIC12C508509to control stepping motor, use PIC12C508A controlling model source and PIC12C509 control LED

共搜集了13个有关51单片机的一些基本程序，代码有汇编写成，内容包括计数器、温度检测等等。-collected a total of 13 of the 51 SCM some of the basic procedures, a compilation of code written, including counter, temperature measurement, and so on.

tlc1542的操作代码，使用keilc编写-tlc1542 operation code, the use of the preparation of keilc

PS7219单片机显示的源程序-PS7219 show the source SCM

Proteus仿真实例，单片机学习的好帮手-Proteus simulation, single-chip learning a good helper

STC12C5410AD温湿度采集并将模拟量通过对半查找法查表转换-STC12C5410AD simulation of temperature and humidity and the amount collected through semi-look-up table to find the conversion law

mcu_PPP在一个单片机上实现PPP协议详解.rar-mcu_PPP in a microcontroller to achieve PPP Elaborates on. Rar

CAN三台机子互相通讯（机子3程序），已调通，标准的标识符，11位。-CAN communication with each other three loom (loom 3 procedures), Qualcomm has been transferred, the standard identifier, 11.

单一灯的左移右移分别接在单片机的P1.0－P1.7接口上，输出“0”时，发光二极管亮，开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮，重复循环-A single light, respectively, shifted to right then left at P1.0-P1.7 microcontroller interface, the output " 0" when the bright light-emitting diode, the beginning of P1.0 → P1.1 → P1.2 → P1. 3 → ┅ → P1.7 → P1.6 → ┅ → P1.0 Liang, repeat cycle